Thingiverse
Nema 17 Holders for Wirechain Prusa i3
by schmiddim
46
Downloads
26
Likes
1
Makes
2015-02-26
I seperated the part for the Z-axis. The old design reduced the max height of printing parts. Install the axis holder on the plate and attach the chain guide with 2 M3 screws.
* Work in progress *
The concept is, that all wires from the Extruder and the x-axis stepper go to the upper left corner via wirechains and from there to the RAMPS board on the back of the printer.
Use the chain parts from http://www.thingiverse.com/thing:10946 (Wire-chain-20mm-Link-sNi (1).stl).
O
I seperated the part for the Z-axis. The old design reduced the max height of printing parts. Install the axis holder on the plate and attach the chain guide with 2 M3 screws.
* Work in progress *
The concept is, that all wires from the Extruder and the x-axis stepper go to the upper left corner via wirechains and from there to the RAMPS board on the back of the printer.
Use the chain parts from http://www.thingiverse.com/thing:10946 (Wire-chain-20mm-Link-sNi (1).stl).
O
Sign in to leave a comment
Sign in