Thingiverse
4AA Battery Holder
door AndreaRade
22
Downloads
19
Likes
0
Makes
This is a 4AA battery case (58,5x61,5x16mm).
It needs a little bit of soldering and copper cables.
It can be a little bit difficult to pass all the cables inside the holes.
I suggest to bend the end of the cable to go in easier and a needle to take it out from the holes.
Starting from the holes at the bottom was easier for me.
It needs a little bit of soldering and copper cables.
It can be a little bit difficult to pass all the cables inside the holes.
I suggest to bend the end of the cable to go in easier and a needle to take it out from the holes.
Starting from the holes at the bottom was easier for me.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
