Thingiverse
4mm scale GWR platform barrow
door Grangewood
3
Downloads
4
Likes
0
Makes
4mm scale (00) GWR platform barrow or trolley.
Can be printed on either an FDM printer or a resin printer. The files for resin printing are prefixed Resin and there is a pre-supported file for resin printing.
I have printed these in both formats successfully.
The photos show the resin prints.
For FDM filament printers, the parts should all print flat on build plate without support, however, the parts are small and may be difficult to remove from build plate.
Glue together with either super glue of EMA models Plastic Weld. The handle will require the hole opening out to take a short length of 0.4mm brass wire or similar.
Can be printed on either an FDM printer or a resin printer. The files for resin printing are prefixed Resin and there is a pre-supported file for resin printing.
I have printed these in both formats successfully.
The photos show the resin prints.
For FDM filament printers, the parts should all print flat on build plate without support, however, the parts are small and may be difficult to remove from build plate.
Glue together with either super glue of EMA models Plastic Weld. The handle will require the hole opening out to take a short length of 0.4mm brass wire or similar.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!