Thingiverse
4Runner AC vent adjustment piece
door ZapRowsdower
34
Downloads
31
Likes
0
Makes
This piece goes in the 2 middle A/C vents on the dash of a 4th gen 4Runner. I don't know if they will work on a previous or later generation of 4Runner or other toyota models.
I printed mine in PLA, but it was more rigid than the original piece, which made it a little harder to get the pegs into the holes. So maybe try a slightly more flexible material. I did make the holes slightly larger so that might help.
The side with the thinner areas near the holes should be facing the pegs.
if scale is wrong the length is: 79.5251 mm
I printed mine in PLA, but it was more rigid than the original piece, which made it a little harder to get the pegs into the holes. So maybe try a slightly more flexible material. I did make the holes slightly larger so that might help.
The side with the thinner areas near the holes should be facing the pegs.
if scale is wrong the length is: 79.5251 mm
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
