MakerWorld
Electronics
Zum Modell
5.5mm Dust Plug
21
Downloads
5
Likes
11
Makes
Hi! This was created as a way to keep people from plugging in power to an unused port on a device, which had 2, when they were asked to unplug it, wait a bit, and then plug it back in.(I know… you would think they would just plug it back into the one they unplugged it from, but people still get confused.) Decided to share it here to help anyone who may need it, or to just use as a way to keep dust out on any ports. The ones I made were in PLA because the device is in a server rack in an AC room. I would recommend printing in a more heat resistant material if you plan to use it anywhere or store the device anywhere where it can get above ~100+ degrees Fahrenheit, or ~40+ degrees Celsius.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
