MakerWorld
Electronics
Zum Modell
5/8" Mic Stand
146
Downloads
31
Likes
35
Makes
This is my Mic Stand that I am currently using. Uses a 5/8" mount. The printed threads for the pole can be temperamental, remember its plastic. Be careful screwing the mount onto the threads. Get it started straight and start twisting, it will be tight. It can be extended an infinite amount, just print more extensions and more base nuts! Extensions are not needed so if you need something short, print one base nut and no extension. No brim, 100% infill on the ring and the mic pole mount (trust me on the pole mount) 1mm layer height on the base nut (you may have 1-3 strands of filament that wont connect, this is unintentionally normal, just pull them off and it'll be fine. Requires 4 m3 heat inserts and m3 screws for the shoe. Can be printed and used without the shoe.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
