Thingiverse
5" Drone Racing/Freestyle Frame
von AWELTIG
31
Downloads
20
Likes
0
Makes
This is an originally designed 5" frame. Very durable and rigid.
Check out its big brother, the 6" version. https://www.thingiverse.com/thing:2599165
Please consider supporting me on Patreon. It helps me make more things. Thank you.
Patreon Link: https://www.patreon.com/ABHIW
The little square plate is used to hold a VTX or receiver on the top of your stack. The other plate is a battery protector. The little hole in the back is for an Sma pigtail and the hole in the front is for a buzzer. To mount the canopy to the main plate you use two M3 screws that come with your motors. You can use the short or long depending on your camera.
Recommended Parts:
2204-2306 motor 2000kv-2750kv
20-30a esc (depends on prop)
5030-5060 bi-quad blade
Any flight controller and PDB will do
Runcam swift or similar
Any VTX will do
Any receiver will do
Check out its big brother, the 6" version. https://www.thingiverse.com/thing:2599165
Please consider supporting me on Patreon. It helps me make more things. Thank you.
Patreon Link: https://www.patreon.com/ABHIW
The little square plate is used to hold a VTX or receiver on the top of your stack. The other plate is a battery protector. The little hole in the back is for an Sma pigtail and the hole in the front is for a buzzer. To mount the canopy to the main plate you use two M3 screws that come with your motors. You can use the short or long depending on your camera.
Recommended Parts:
2204-2306 motor 2000kv-2750kv
20-30a esc (depends on prop)
5030-5060 bi-quad blade
Any flight controller and PDB will do
Runcam swift or similar
Any VTX will do
Any receiver will do
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!