Thingiverse
Electronics
Voir le modèle
5 mm LED holder
64
Téléchargements
57
Likes
1
Makes
This LED holder is for a 5 mm LED.
The hole for this LED holder should be 7 mm.
The inner radius, in which the LED snaps into place, is smaller than the LED and should therefore secure the LED holder in the hole against falling out (see pictures with caliper).
In addition I also places in the project a tool, to remove the LED off the LED holder.
You can use both sides, but the side with the cut, is for the LED wire when they are bent.
Update:
I just noticed, the the dimensions are of course not in m but in mm.
The hole for this LED holder should be 7 mm.
The inner radius, in which the LED snaps into place, is smaller than the LED and should therefore secure the LED holder in the hole against falling out (see pictures with caliper).
In addition I also places in the project a tool, to remove the LED off the LED holder.
You can use both sides, but the side with the cut, is for the LED wire when they are bent.
Update:
I just noticed, the the dimensions are of course not in m but in mm.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
