Thingiverse
5" Touchscreen for Raspberry Pi.
door superkris
102
Downloads
56
Likes
0
Makes
This is a remix from the 5" touchscreen mount that fits the Anycubic Kossel Plus printer. It mounts to the bottom frame of this printer but this remix is also suitable for other printers. Use the existing brackets, or build your own!
Do you have a Anycubic Kossel Plus and do you want to keep the original display? Have a look at the original design:
https://www.thingiverse.com/thing:3940357
**Also looking for some hardware to mount your raspberry? Check out these designs:**
Raspberry pi mount: https://www.thingiverse.com/thing:3912074
Power supply mount: https://www.thingiverse.com/thing:3912130
Accessory switch mount: https://www.thingiverse.com/thing:3912189
**Assembly**
- Remove spacers and mouting screws from the display.
- Use M3 screws to attach the display frame to the frame. Just let them tap into the plastic. Max length 8mm
- Use M4 bolts and T-nuts to attach the right and left bracket to the frame of the printer. Depending on the orrientation of you display, y
Do you have a Anycubic Kossel Plus and do you want to keep the original display? Have a look at the original design:
https://www.thingiverse.com/thing:3940357
**Also looking for some hardware to mount your raspberry? Check out these designs:**
Raspberry pi mount: https://www.thingiverse.com/thing:3912074
Power supply mount: https://www.thingiverse.com/thing:3912130
Accessory switch mount: https://www.thingiverse.com/thing:3912189
**Assembly**
- Remove spacers and mouting screws from the display.
- Use M3 screws to attach the display frame to the frame. Just let them tap into the plastic. Max length 8mm
- Use M4 bolts and T-nuts to attach the right and left bracket to the frame of the printer. Depending on the orrientation of you display, y
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
