Thingiverse
5 (€uro) Cent Spinner
di MasterFX
23
Download
17
Likes
0
Makes
Just another Fidget Spinner which uses 5 Euro-Cent coins (4x for each arm).
It is a little bit bigger in diameter and heavyer than using 608Z bearings (72.3g instead of 54.8g)
I recommend the caps from 2ROBOTGUY's design: http://www.thingiverse.com/thing:1802260
The Coins are nestled inside the spinner, so you have to pause the print right before the first top solid layer begins (0.4mm before end). If you are using 0.2mm layer resolution you have to stop between layer 36 and 37.
In Simplify 3D you can use the post processing command. For my Prusa I3 clone (Anet A8) the code looks like this;
{STRIP "; postProcessing,"}
{REPLACE "; layer 37," "G91 \nG1 Z10 \nG90 \nG1 X0 Y200 \nM0 Click To Restart \nG91 \nG1Z-10 \nG90 \n; layer 37,"}
It is a little bit bigger in diameter and heavyer than using 608Z bearings (72.3g instead of 54.8g)
I recommend the caps from 2ROBOTGUY's design: http://www.thingiverse.com/thing:1802260
The Coins are nestled inside the spinner, so you have to pause the print right before the first top solid layer begins (0.4mm before end). If you are using 0.2mm layer resolution you have to stop between layer 36 and 37.
In Simplify 3D you can use the post processing command. For my Prusa I3 clone (Anet A8) the code looks like this;
{STRIP "; postProcessing,"}
{REPLACE "; layer 37," "G91 \nG1 Z10 \nG90 \nG1 X0 Y200 \nM0 Click To Restart \nG91 \nG1Z-10 \nG90 \n; layer 37,"}
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
