501st Clone Stealth Pilot Chest Box
door 87ninefiveone
61
Downloads
27
Likes
0
Makes
I modeled this up for a friend and thought that I would share. The design is based on screen shots from the Clone Wars TV show and meets the current CRL requirements for use in the 501st legion. The fourth photo shows an overlay of the design with a photo of the acceptable version listed in the 501st CRL.
A couple of notes:
1. I have included holes on the rear to mount to a chest plate. The holes have been modeled with 1/4-20 threads and are 1" deep. I would recomend the use of 1/4-20x3/4" or 7/8" screws for mounting.
2. There are two versions, one which is solid, and another with a hollowed out back. They'll use about the same amount of material when printing, but the hollowed version will weigh about 1/3 less after supports are removed. Total material weight should be in the 300-400g range when printed.
3. The box is about 7x5x2, you may need to rescale it based on your size and chest armor for 501st approval.
A couple of notes:
1. I have included holes on the rear to mount to a chest plate. The holes have been modeled with 1/4-20 threads and are 1" deep. I would recomend the use of 1/4-20x3/4" or 7/8" screws for mounting.
2. There are two versions, one which is solid, and another with a hollowed out back. They'll use about the same amount of material when printing, but the hollowed version will weigh about 1/3 less after supports are removed. Total material weight should be in the 300-400g range when printed.
3. The box is about 7x5x2, you may need to rescale it based on your size and chest armor for 501st approval.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
