Thingiverse
Yet another Bus Pirate enclosure
by SteveDC
15
Downloads
8
Likes
1
Makes
Couldn't find quite the Bus Pirate case I was looking for so threw this one together.
It is designed for the 3.6 version of the Bus Pirate but will probably accommodate other versions.
It is just about as small as it can be, snug but should not require forcing in.
As with all printed parts you might need to slightly adjust things to make the top 'snap' to the bottom snugly. Alternatively you can use glue on the lid.
If this works for you then great. If not, sorry :)
It is designed for the 3.6 version of the Bus Pirate but will probably accommodate other versions.
It is just about as small as it can be, snug but should not require forcing in.
As with all printed parts you might need to slightly adjust things to make the top 'snap' to the bottom snugly. Alternatively you can use glue on the lid.
If this works for you then great. If not, sorry :)
Sign in to leave a comment
Sign in