Thingiverse
52mm dish wheel
door longuylander
3
Downloads
5
Likes
0
Makes
A simple dish style wheel for 1:10 touring cars. Standard 12mm hex. Prints quite well face down, saving a lot of time not printing supports. Support is still needed for the small indentation where the nut attaches to the axle.
I've been working on getting the distance between the back of the hex to the front of the wheel correct. Right now, it seems a bit thick, but enough of the axle does emerge to comfortably secure the wheel.
I've been working on getting the distance between the back of the hex to the front of the wheel correct. Right now, it seems a bit thick, but enough of the axle does emerge to comfortably secure the wheel.
longuylander publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!