Gizmacci Four - hinges for 1/8 inch sheet

This gizmacci is an element in my 3D Printer Enclosure.

These are hinges for the door to the enclosure. The pin the hinge hangs from is a section of 3.0 mm ABS filament that has the end "peened" with a hot element, like a soldering iron. You can clean out the hinge holes with a 1/8" drill bit which is just a tiny bit bigger than 3.0mm.


These are designed for 1/8 inch-thick plexi sheets. There are two outside hinge elements that sandwich the middle hinge on the door. Mate the bottom e