Thingiverse
57 cm Right Angle Bracket
von Nutz95
31
Downloads
12
Likes
0
Makes
This part is for 3030 aluminum extrusion.
It should fit inside the extrusion. The size of the small plastic side that goes inside the extrusion is about 7.8mm wide.
It should fit inside the extrusion. The size of the small plastic side that goes inside the extrusion is about 7.8mm wide.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
