Thingiverse
Y-Carriage 3d-plexi-printer
by steijlen
17
Downloads
13
Likes
0
Makes
This is my Y-Carriage (with Motor) to be used in my new to develop 3d-plexi-printer.
It can hold a NEMA 17 motor. You can adjust it to tighten the y-timing belt.
It has a piece to act with an optical end stop.
You need the other Y-Carriage (without Motor) on the opposite side of the printer.
It is made for 8mm steel rods and T2.5 timing belt.
Just examine the file to see if you can use it.
For any questions please contact me.
It can hold a NEMA 17 motor. You can adjust it to tighten the y-timing belt.
It has a piece to act with an optical end stop.
You need the other Y-Carriage (without Motor) on the opposite side of the printer.
It is made for 8mm steel rods and T2.5 timing belt.
Just examine the file to see if you can use it.
For any questions please contact me.
Sign in to leave a comment
Sign in