Thingiverse
J Head fan duct
by peke
84
Downloads
53
Likes
2
Makes
**************** UPDATED *************************
Thickness in the lower part reworkd, printed OK .
*******************************************************
I tried to creates something light to cool down the cold part of the head.Walls are 1mm thick.
The square holes are designed to secure the installation with a small zip tie.
This new version should clip by itself on the head if not, a short time under an air dryer should help.
Compared to the photo shown, the duct has been rezise
Thickness in the lower part reworkd, printed OK .
*******************************************************
I tried to creates something light to cool down the cold part of the head.Walls are 1mm thick.
The square holes are designed to secure the installation with a small zip tie.
This new version should clip by itself on the head if not, a short time under an air dryer should help.
Compared to the photo shown, the duct has been rezise
Sign in to leave a comment
Sign in