Thingiverse
Noise isolating feet 6mm, PrintrBot Simple Makers kit (wooden)
by jonnor
3
Downloads
2
Likes
0
Makes
Designed for NinjaFlex material. Slip onto 6mm wood/acrylics to reduce noise transfer to underlying surface.
No support needed. Recommend 50-100% fill rate to not be too flexible. Printed at 20 mm/s, 2 pieces at a time. 30 would probably also have been fine.
Not tested with Flexible PLA, but might also work well. If using rigid material for noise reduction should use a spike shape instead of cylinder.
No support needed. Recommend 50-100% fill rate to not be too flexible. Printed at 20 mm/s, 2 pieces at a time. 30 would probably also have been fine.
Not tested with Flexible PLA, but might also work well. If using rigid material for noise reduction should use a spike shape instead of cylinder.
Sign in to leave a comment
Sign in