Thingiverse
58-72mm Step-Up Adapter Ring
von pomtazel
8
Downloads
4
Likes
0
Makes
This is a step up ring.
I recommend you to set the FDM's Z pitch to 0.10 or 0.15mm because of the thread portion is very delicate.
Please check out that the thing you print might not be fall off from your camera before use this.
I recommend you to set the FDM's Z pitch to 0.10 or 0.15mm because of the thread portion is very delicate.
Please check out that the thing you print might not be fall off from your camera before use this.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!