Thingiverse
PrintrBot LCD Housing, adjusted
by DavidYon47
13
Downloads
6
Likes
0
Makes
Similar to original, but with a smaller opening for the LCD so that the circuit board is no longer visible. Also tweaked the ribbon cable exit slot such that it captures the cable.
Could use more work as the circuit board is no longer flush with the screw holes (just use long enough screws and don't over-tighten), and the right side of the bevel could come in an extra 3-4mm to better center the display.
Could use more work as the circuit board is no longer flush with the screw holes (just use long enough screws and don't over-tighten), and the right side of the bevel could come in an extra 3-4mm to better center the display.
Sign in to leave a comment
Sign in