Thingiverse
Housing for AbuseMark AfroMini32
7
Downloads
5
Likes
0
Makes
This is a housing I did using FreeCAD for the AbuseMark AfroMini32 version of the Naze32.
The housing is done for 90° pins on the FTDI port and straight pins for the servo outputs and PPM input.
There are two versions:
1 without additional attachment points, one with 31x31mm screwing pattern used for the bigger version of the Naze32.
Do not forget to place open cell foam on the baro...
Feel free to modify & distribute.
The housing is done for 90° pins on the FTDI port and straight pins for the servo outputs and PPM input.
There are two versions:
1 without additional attachment points, one with 31x31mm screwing pattern used for the bigger version of the Naze32.
Do not forget to place open cell foam on the baro...
Feel free to modify & distribute.
Sign in to leave a comment
Sign in