Thingiverse
58mm Filter Holder
12
Download
13
Likes
0
Makes
This is a remix of the excellent lens filter case by TheCrazyPrinter.
I found that the logo that that's in the bottom slows down the printing, so I decided to remove it using MeshMixer.
This design features some cutouts in the bottom part to help in grabbing the filters.
There's also a small hole to pass a string through so you can tie the case outside the camera bag.
To adjust the filter holder, just change the scale on the slicer.
Original is for 3x58mm filters.
For (filter size) Scale X and Y axes to:
49mm - scale 84.4%
52mm - scale 89.6%
55mm - scale 94.8%
62mm - scale 106.9%
Once freshly printed, the case will be a bit hard to screw together. Once you have it screwed, work it back and forth to wear-out the plastic. Once the edges from the original mesh are all worn out a bit, it should screw together just fine.
I found that the logo that that's in the bottom slows down the printing, so I decided to remove it using MeshMixer.
This design features some cutouts in the bottom part to help in grabbing the filters.
There's also a small hole to pass a string through so you can tie the case outside the camera bag.
To adjust the filter holder, just change the scale on the slicer.
Original is for 3x58mm filters.
For (filter size) Scale X and Y axes to:
49mm - scale 84.4%
52mm - scale 89.6%
55mm - scale 94.8%
62mm - scale 106.9%
Once freshly printed, the case will be a bit hard to screw together. Once you have it screwed, work it back and forth to wear-out the plastic. Once the edges from the original mesh are all worn out a bit, it should screw together just fine.
Build-0-Matic pubblica anche su
8 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
