Thingiverse
Pillar Statue
by mechadense
42
Downloads
34
Likes
2
Makes
My first try to scan with photos and 123D Catch.
I guess this thing is supposed to be used for a flower pot but it was used for a table here. The original was about very roughly 80cm high.
The BY-NC-SA license is enforced by Autodesk. See here:
http://sitesupport.123dapp.com/entries/20059427
under 3. Your content (ii)
Interesting fact:
In the tutorial videos there where three resolutions to choose from but I could choose only from two. I hope they didn't remove the highest resol
I guess this thing is supposed to be used for a flower pot but it was used for a table here. The original was about very roughly 80cm high.
The BY-NC-SA license is enforced by Autodesk. See here:
http://sitesupport.123dapp.com/entries/20059427
under 3. Your content (ii)
Interesting fact:
In the tutorial videos there where three resolutions to choose from but I could choose only from two. I hope they didn't remove the highest resol
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in