Thingiverse
5cm buckle
por The_Sloth_Lord
4
Descargas
4
Likes
0
Makes
Replacement for 5cm buckle. I printed it in PLA (Only filament i had) and it worked ok. its a bit stiff, but feels sturdy. I recommend using a better suited material.
I printed it flat with a bunch of support underneath the hole thing. I used 6 perimeters for good flexibility and strength in the parts that are going to be bent.
Afterwards i sanded down where the supports had been, to make the buckle fit nicely.
I printed it flat with a bunch of support underneath the hole thing. I used 6 perimeters for good flexibility and strength in the parts that are going to be bent.
Afterwards i sanded down where the supports had been, to make the buckle fit nicely.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
