Thingiverse
5LB Spool Holder
von jcprintnplay
14
Downloads
16
Likes
2
Makes
I was recently gifted several rolls of IC3D filaments on 5LB rolls. Since they didn't fit onto any of my existing spool holders, I modeled this one up in Fusion 360. Was printed at 0.2 layer height with 20 percent infill, 3 outer perimeters, and 4 top/bottom layers, and turned out very solid.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
