Thingiverse
Hobby
Model downloaden
6-13mm Combination / Ring Spanner Pegs
519
Downloads
370
Likes
1
Makes
A simple hanging holder for Combination Spanners. This fits the 6-13mm half of the set.
Holds 2x Spanners.
There is also a thing for the 14-19mm half of this set too.
https://www.thingiverse.com/thing:6152285
Colour the end in, or run a dual colour print.
Make this nice and strong, ideally ABS or PET-G with a high infill and wall count.
The holes on the rear fit a standard Bott Perfoboard. Either bolt to the back, or affix through the holes. There isn't anything to locate from, so can also be fitted to a shadowboard or a wall.
Holds 2x Spanners.
There is also a thing for the 14-19mm half of this set too.
https://www.thingiverse.com/thing:6152285
Colour the end in, or run a dual colour print.
Make this nice and strong, ideally ABS or PET-G with a high infill and wall count.
The holes on the rear fit a standard Bott Perfoboard. Either bolt to the back, or affix through the holes. There isn't anything to locate from, so can also be fitted to a shadowboard or a wall.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
