6" Filament Spool Holder

NOTICE: NOT MADE FOR 1KG SPOOLS OF FILAMENT
This is a 6" filament spool holder designed specifically for Gizmo Dorks 6" 200g spools of filament. Other spools can be used up to 6" O.D. and no less than 1.2" I.D. with a maximum of 2.2" width This is also designed to fit in a 21 cup modular 'Rubberhousekeeper' custom made drybox as shown in the picture, will also work with your drybox even if it has the pneumatic fitting on the lid or bottom of the side. Finished product width 3.125" height 5.637" and depth 6"

Required Hardware: 8xM3 Brass threaded inserts, 8xM3x12mm button head screws, and 2x608-2RS bearings

Printing: For the upper and lower cross braces it is recommended to use 100% infill for stability and so the brass threaded inserts hold well, and to print them lying down.
For the two sides I recommend printing with a minimum of 25% infill when using cubic pattern so the bearing mounts have some infill in them and they don't crush when bearings are added, also print laying