Thingiverse
6 layer Sunglasses Stand
by DJIMini2
75
Downloads
284
Likes
0
Makes
This is a 6 layer sunglasses stand that fits most sunglasses. It does not need any supports at all and can be printed on a 12 by 12 inch printer. The only way to get part C on the print bed is if you print it diagonolly.
I reccomend printing part A at 100% infill (for a heavier base), part B also at 100%, and part C at 30%.
I reccomend printing part A at 100% infill (for a heavier base), part B also at 100%, and part C at 30%.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
