RifRaf Terraforming Mars Tiles Storage

This is adapted from an excellent design by JimmyJammer Terraforming Mars trays, (THANKS!) Added Sept 2019: Added a 5 bay top and base Note: If you are having trouble printing due to PLA curling up along the long sides, slow your print way down to 20-40% total print speed at the printer and try again... these have never failed at that speed for me. I printed two 4-bay and one-3Bay..and it holds the following RifRaf TM tiles: -33 Trees -16 Generic Cities (Printed 8 regular and 8 mirrored) -11 Special cities -11 Card Cities -9 Ocean tiles -5 Venus Next Tiles -1 Colonies Tile -1 Prelude Tile -4 Bonus Tiles 91 Total RifRaf TM FULL Tile SET If you print and stack the cities as shown in the picture that says "91 Tiles" the full set as indicated fits. I am not sure if any other way will fit them all. The full tray set printed fine with NO supports, just slow the speed down.. Jan 2019...I uploaded in the main section the Nuke and Gyropolis SMALLER tiles for if you plan on using the storage bins then these tiles fit much better. It is made like the original files to fit magnets 6mm diameter x 1mm deep, but I have not tried this yet. I printed on a Prusa Mk2S in PLA with a .40 Nozzle at .15mm layer height with no supports BUT NOTE: If you printed the ORIGINAL Nuke and Gyropolis… I had to take a solder Iron to melt out 4 spots in a base and top for the Nuke and Gyropolis tiles...I have POSTED updated smaller Nuke and Gyropolis tiles to fix this issue.... Also I have not added any magnets yet so not sure how this may change things. Printed with detect bridges is needed, but no supports. I made a 4 bay, 3 Bay, 2 Bay and 1 bay storage, highlights with a label and bases so you can print without supports and stack a 4 on a 5, 3 on a 4, a 2 on a 3 and a 1 on a 2 (two 1s will NOT stack on a 3)...The 1 bay is probably not stable to stand on its own but is included just because it could be useful. They fit the RifRaf Tiles snugly, I don't know about any others. I will print soon and po