Thingiverse
Clip-on Printrbot brushless blower turbine fan mount
by zachnfine
38
Downloads
29
Likes
0
Makes
This is a clip-on mount for attaching a brushless blower fan to a Printrbot+ extruder. Assuming the extruder dimensions are constant, this will likely work for all Printrbots with laser-cut wooden extruders.
It was designed to work with a 5015S blower fan purchased from eBay for $4.89, which is 50mmx15mm high, runs at 3800rpm, and puts out 20CFM. It runs circles around the 40mm PC fans I'd tried previously to use to cool filament.
In the photo, it looks as though the bottom edge of the b
It was designed to work with a 5015S blower fan purchased from eBay for $4.89, which is 50mmx15mm high, runs at 3800rpm, and puts out 20CFM. It runs circles around the 40mm PC fans I'd tried previously to use to cool filament.
In the photo, it looks as though the bottom edge of the b
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in