3D Printer Parts STL Download - Ender 3 Series Light Bar - Dual LED Strips - Z-Axis Stablizeby syntax1269

Easy to print on any 220x220 3D printer. This Light Bar will fit Ender 3 series printer that has a 220x220 print bed. There are three parts to this and it is a tight fit but that is on purpose so everything will hold together when mounted on the printer. The Base Will fit tight but should not need any trimming, tested at a few resolutions.Once its in the aluminum just click your guide in and call it a day.Wires are hidden and tucked away in the Left arm of the light and makes the overall apparance neater overall. You can put two strips in the holder for extra light but one should be enough in most cases.If you need to run wires on the reverse side just need to mirror the arm in your slicer and they will fit just the same. Enjoy!For the Z-Axis stabilizer you will need to obtain a ZZ608 22mm OD 8mm Bore Diameter Ball Bearing to insert into the housing.* If your printer hates to bridge, Print end clip with support lines at 1.8mm apart (5 lines total under roof) only touching build plate. * Don't forget to cut any strands filling the top pillar or it will provide a lot of resistance.# Print SettingsPrinter: Ender 3Rafts: Doesn't MatterSupports: Yes, Only on Left arm and Z-Axis Stabilizer with Guide option Must use Support Blocker function in Cura for the hidden wire tubeResolution: .15 to .18Infill: 10% +