Thingiverse
Mudguard washers for Automatic belt tensioner for RepRap Prusa Mendel
6
Downloads
6
Likes
0
Makes
Building on from the great work of u-design.
During assembly of Automatic belt tensioner for RepRap Prusa Mendel by u-design i discovered I did not have any mudguard washers.
These mudguard washers have a small step close to the inside hole to prevent binding of 608 bearing and washer.
Before this I could not get great looking prints (arcs were not even due to constant slipping due to loose y-axis belt).
A welcome side effect is the I have decreased the voltage to the Y-axis stepper
During assembly of Automatic belt tensioner for RepRap Prusa Mendel by u-design i discovered I did not have any mudguard washers.
These mudguard washers have a small step close to the inside hole to prevent binding of 608 bearing and washer.
Before this I could not get great looking prints (arcs were not even due to constant slipping due to loose y-axis belt).
A welcome side effect is the I have decreased the voltage to the Y-axis stepper
Sign in to leave a comment
Sign in