3D Printer Accessories STL Download - Ender3_Gantry_Cam.stlby anonymous 4664

This is a remix of the Wyze Cam Gantry Mount for the Ender 3.With this remix, I had the following goals in mind:I wanted to position my Wyze Cam v2 base at an angle. This is necessary to avoid a tilted image on the camera when you pan and tilt the camera down to face the print bed.I wanted to be able to use the same mount with other cameras that support a 3/8in tripod screw. Wyze Cams can still use this mount with the provided magnetic washer and double-sided tape, which allows the camera to be rotated freely.I wanted to simplify the print by reducing the need for supports, so I eliminated the top bubble. This also creates an unobstructed path for the camera cable to be ran with sticky cable clipsI wanted to fix a fitting issue I encountered with the original model where it was too small to fit over the motor housing without cracking.Print SettingsPrinter brand:CrealityPrinter:Ender 3 ProRafts:NoSupports:YesResolution:200Infill:5% GyroidFilament brand:eSUNFilament color:AnyFilament material:PLANotes:This model is designed to print on its side with supports for the box cover.I printed this with adaptive layer heights enabled and shaved off an hour of print time, with no noticeable drawbacks to the strength or quality of the finished print.Post-PrintingAdjustmentsI corrected the X and Z dimensions based on caliper measurements done on my printer and added a 0.2mm allowance for an easy but snug fit. My printer's motor housing measured 40.3mm x 40.0mm (HxW). If the fit is loose or you just want that added security, you can also place a strip of double-sided mounting tape on the inside face of the box cover to hold it in place.