Honda Odyssey 1999-2004 sliding door handle lever

This part broke on both sliding doors. However I don't know if it's the same on both sides. This one was designed for the left sliding door.
This part was designed to be a bit stronger than the original. A bit thicker in most areas.
Print with 100% infill for strength. On my RepRap I had to set Slic3r to pause 2 seconds between layers so allow the PLA to cool.
Update 8/28/15 - The one made from PLA bent. Must have been too hot in the door. A new one made from ABS is going into the door