64mm EDF JET Project

This is one of my favorite CAD creations so far. This is an idea I had a little while ago and decided to prototype in cad. I came up with a very nice design, but only had a 30mm inner channel. I may upload the 30mm also. Ideally, this would fit a small 6 channel receiver, 64mm EDF motor, battery anywhere from 500 to 2000 mAh (as long as it fits), ESC, and wiring. There are no holes for wiring, so you may have to make some. I really hope someone tries this out. Assuming you don't already have any of the electronics, total build cost could be between $150 and $250, though there's technically a very large limit.

I named this project the FDEDF, short for Fuselage- Ducted EDF jet.