64x32 LED Matrix Case Extended

I had a regular Raspberry Pi 3B+ with an adafruit hat, so I couldn't fit in the specified case. I imagine this could've been done more efficiently, but I'm just learning Autodesk Fusion 360. I extended it to about 43mm deep so I could fit everything in. I didn't modify the front piece.

Few things to note:

* I didn't utilize the Pi mount points. Mine is just floating around, but I don't move it.
* The screws can be difficult to get in correctly. I picked up M3-16mm button cap screws and it took a bit to fit properly.
* I had to drill out the cord slot with a 1/2" drill bit. I had a barrel connector to the adafruit hat, and it wouldn't fit in the stock hole. I didn't think to widen it before I printed it.