Thingiverse
Spool holder for Prusa RepRap
by Hackens
0
Downloads
0
Likes
0
Makes
mount as specified in screenshot
The horizontal bars can be either threaded rods or simple rods
The filament holder can be used to hold in place a piece of cloth to clean the filament before it is extruded
You can split the filament holder in two and clamp it around the horizontal rods using the small screw holes. This way you can install/remove the filament holder without unmounting the whole setup each time.
Mount the filament spool on the cylinder, and support it with 22mm ball be
The horizontal bars can be either threaded rods or simple rods
The filament holder can be used to hold in place a piece of cloth to clean the filament before it is extruded
You can split the filament holder in two and clamp it around the horizontal rods using the small screw holes. This way you can install/remove the filament holder without unmounting the whole setup each time.
Mount the filament spool on the cylinder, and support it with 22mm ball be
Sign in to leave a comment
Sign in