Thingiverse
沢 すみれ
von MasterMOULD-1980
7
Downloads
32
Likes
0
Makes
PROPERTY OF SEGA. USED WITHOUT PERMISSION.
printed in 1:8 x 300%. i've been putting off finishing this model since last fall, simply because of the hair, but i picked it up recently and suffered through it. its not great, it printed properly on the first print with the expected 'webbing' happening in the back between her hair and coveralls. there was a split above her breasts that's already been resolved in the latest BLEND and STL.
the model was optimized further after printing. i noticed some large faces in the coveralls i forgot to subdivide as well as a huge cap on the chest which i fanned out and subdivided as well for cleaner booleans. hard hat parts were also thickened and optimized and the band was anchored so it wouldn't float around. some hair ends were also scaled proportionally to their tips.
ENJOY!
don't forget to hollow your STL in PrusaSlicer.
one more note, the model is 3xSS but the coveralls are set to 4xSS because they are much lower poly than th
printed in 1:8 x 300%. i've been putting off finishing this model since last fall, simply because of the hair, but i picked it up recently and suffered through it. its not great, it printed properly on the first print with the expected 'webbing' happening in the back between her hair and coveralls. there was a split above her breasts that's already been resolved in the latest BLEND and STL.
the model was optimized further after printing. i noticed some large faces in the coveralls i forgot to subdivide as well as a huge cap on the chest which i fanned out and subdivided as well for cleaner booleans. hard hat parts were also thickened and optimized and the band was anchored so it wouldn't float around. some hair ends were also scaled proportionally to their tips.
ENJOY!
don't forget to hollow your STL in PrusaSlicer.
one more note, the model is 3xSS but the coveralls are set to 4xSS because they are much lower poly than th
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
