Home Decorations & Ornaments STL Download - Frog Faux Stained Glass Frameby Phase888

These frames are what I use for faux stained glass decorations for various themes. I print them then fill them with tinted or filled non-UV resin on my fdm printers. They take a fair amount of time to dry however the results do quite well. I was printing so many of these during certain holidays that I have an Ender 3 v3 se set up exclusively to print frames. I also print any overflow on my K1/K1 Max however I like to use those for longer prints or things that require higher accuracy.I print these in speedy settings basically with no brim or supports. I change Infill to gyroid and usually print them at 100% infill but I have done them at less. These print fairly quickly and as I have a printer just for these I'm not as concerned with how long they take. They also do not use a large amount of filament so cost isn't an issue either as the difference between 50 and 100 is minimal. When I printed them with less infill I had issues with resin seepage, leaking and general stablity of the frame but this starts to go away over 50%. More infill makes them easier to get off the E3's bed without concern for them sticking a bit too well and cracking. I use regular PLA with no special considerations.Iniital Layer - .2mmLine layer - .2mmInfill - gyroid at 50-100%No supportsNo brim