Other STL Download - "ULTI" Hybrid-Goldsluicebankerby Samuel_Morgan

The "Ulti" hybrid gold panning trough is the ultimate solution for every gold panning trough who wants to have both a gold panning trough and a high banker with them when searching for gold. The "Ulti" Hybrig gold panning trough can be easily folded down and converted into a high banker. The gold washing trough uses 4 Miners Moss mats for the washing process. Four different expanded meshes are also used and a few individual corrugations between the systems. You can also easily attach 4 legs. The 4 legs can also be easily attached to the holder for transport and are therefore easy to store. Additionally, there is now a funnel for the sluice mode that can be easily screwed on and off. For this, there is a turning aid into which you can press an M6 nut (you need to print this aid four times). In addition, the hose connection can be easily screwed on and off. Depending on the quality of your printer and its accuracy, you may have to adjust the width of the expanded mesh so that it sits properly in the end. In addition, the following things are required: 31 screws M6 x 20mm 2 screws M6 x 30mm 29 M6 washers 33 M6 nuts (An M6 wing nut can also be used in the middle to make it easier to remove the base plate) 4 Miners Moss mats with the following dimensions are also required: A: 154mm L x 128mm W x 10mm H B: 96mm L x 138mm W x 10mm H C: 129mm L x 144mm W x 10mm H D: 132mmL x 151mm W x 10mm H And a water hose with a diameter of 4cm (1 1/2 inch) and a hose clamp are required for operation as a high banker (and of course a suitable water pump).