Free Jewelry & Accessories STL Download - Autobots Walletby Popeye1981

Autobots WalletDesigned this wallet for 9 cards and a compartment for cash in FreeCad.I printed using supports everywhere, resolution of 0.16mm height and 100% infill in my Ender 3. Make sure to sand some of the sliding parts and the clips.To mount:Insert the coin cover in the top cover from the hole side (you'll figure it out how it works);Slide the top cover with the coin cover into the body until it fits entirely;Insert the lever to stay in the same position as the photos above;Insert the lever clip (watch out to don't break it, you'll have to make strength);Put the card cover in position of closed and insert the card cover clip (again, do as you did for the lever clip), remember that you may have to sand a little in the end so that you don't make much strength to open and close.