3D Printer Parts STL Download - Filament Detector Holder + Cable Clipby DethLev

A bracket to move the filament detection sensor to right above the extruder making the amount of filament lost when running out significantly less.Included is a cable clip to route the cable along the extruder cable.To reroute this cable you'll have to pull it out from the frame. I advice pulling it out from the top because the connector on the bottom is smaller and otherwise it might not go through.Also check out my full upgrade pack for the E3V3KEhttps://www.crealitycloud.com/model-detail/65ec3bfb0d2c28c07fe39d76