Thingiverse
65mm toothpick drone
di ChristianM67
98
Download
71
Likes
0
Makes
This is a 3d printed toothpick designed for 65mm props. I print the frame in CF nylon and I have crashed it many, many times without breaking the frame. I am sure that you can print with other materials such as PETG but I have not tried it. All parts can be printed without supports.
There are three versions of the frame and they all have a mounting for a 10mm buzzer and RX:
- Stretched X frame with 16x16mm flight stack
- Dead cat frame with 16x16mm flight stack
- Dead cat frame with 20x20mm flight stack
You can choose between a full canopy or a camera mount (16x16mm bolt spacing) for nano sized cameras (14mm wide). These should be printed in TPU but could also be printed in CF nylon.
The quad weights 52 gram all up without the battery so it is not heavier than a CF version
10mm buzzer. This is the equipment list that I recommend:
- Flywoo 16x16mm micro stack and VTX
- Runcam nano 2
- AMAXinno 1103 7500KV motor
- HQ prop T65r 65mm Propeller
- 9mm 5V Buzzer
-
There are three versions of the frame and they all have a mounting for a 10mm buzzer and RX:
- Stretched X frame with 16x16mm flight stack
- Dead cat frame with 16x16mm flight stack
- Dead cat frame with 20x20mm flight stack
You can choose between a full canopy or a camera mount (16x16mm bolt spacing) for nano sized cameras (14mm wide). These should be printed in TPU but could also be printed in CF nylon.
The quad weights 52 gram all up without the battery so it is not heavier than a CF version
10mm buzzer. This is the equipment list that I recommend:
- Flywoo 16x16mm micro stack and VTX
- Runcam nano 2
- AMAXinno 1103 7500KV motor
- HQ prop T65r 65mm Propeller
- 9mm 5V Buzzer
-
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
