Electronics & RC (Remote Control) STL Download - rc remote control catamaran boat 52" big printersby BRADYbish

This is a remix of Power Boat, Speed Boat 36"by Thepael on thingiverse.In the pictures the original is on the left. I dissected it and scaled it to be about 20" larger than the original and it's in 18 pieces. You can double up the pieces on the print bed and do about 8 or 9 prints. I was able to get 4 pieces on on plate.Running the minimum wall thickness at .4mm, I used about 1.5 1kg rolls of pla and print speeds were fast.I'm running it on my k1max with pla+-.12mm layer height-Wall thickness is .4mm (walls are too thin if you go less) a this thickness the infill will show on the exterior. Feel free to adjust as you please. You can see with a light behind the print it is almost transparent, but surprisingly strong.-If you do not plan on reinforcing with fiberglass, I would suggest 2mm walls.-5% infill of your choice- I used cubic subdivision-220° nozzle-60° bed temp-300mm print speedI only used supports on the two transom pieces with the large step. That was 70° overhang with 30% supports.I printed most with auto-brim and the support pieces with regular brim.I run 3 layers of 7oz fiberglass cloth and west system epoxy over the entire hull.I will post more step-by-step photos when I'm done glassing and painting