Creality Tree Topp Star

Creality Christmas Tree Topp StarI have made a star for the Christmas tree and of course with the logo from my favorite supplier of printers.Have made it in the size 188mm so no problem with printing it on most models of printers. If you would like it larger or smaller, just peel it as needed. Upload it in its entirety but also in 2 parts to minimize the support material. The front and back are the same and just glue together after printing.Infill: 15% probably doesn't have to be as it's not any kind of load or similar. Standard quality 0.2mm according to Cura. Drove without support on the 2 parts but on the other that is hole piece it is needed. May possibly need to add build plate adhesion depending on how well calibrated the bed is.Made a change filament on layer 100 but may vary depending on the settings of your printer.According to Cura, it weighs 48 grams and takes 2 h 44 m for each side. A total of 96 grams and 5 h 28 mCan of course change the infill percentage and type depending on what you are looking for.Happy printing !Best RegardsHöök´s 3D-Printing & DesignAnders Höök2024-11-22