Thingiverse
Ingress Portal Key
by kirash4
143
Downloads
121
Likes
3
Makes
This is a respin of 3d0g's original key design seen here: http://www.thingiverse.com/thing:219561
Most of the pieces have pegs that press fit into matching holes. The only two that need to be glued together are the tube parts.
Everything is printed at 100% in-fill to give the pegs the necessary strength, otherwise the top of them will break off. The key can be displayed two different ways as seen in the pictures above. There are holes both on the bottom as well as on the side depending on
Most of the pieces have pegs that press fit into matching holes. The only two that need to be glued together are the tube parts.
Everything is printed at 100% in-fill to give the pegs the necessary strength, otherwise the top of them will break off. The key can be displayed two different ways as seen in the pictures above. There are holes both on the bottom as well as on the side depending on
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in