3-inch Vent W/Waste (poop) Chute. Ditch the bin, bag it!

Design ConceptFocused on a rational structure, perfect combination of function. Strength of the installed vent and ramp not to move and hold tight. A design that not slide or require screwing into the printer causing damage to resale and warranty. In addition, the flexibility of pointing the exhaust tube up or down independent of the others. Pursued aesthetic appearance and optimized internal structure to ensure strength, durability, and practical use. The Bag is better for flexible volumes by bag selection and contamination is better controlled. DITCH THE BINS AND RAMPS!Print SettingsK2 Plus printer, Ramp 17 g 43 min print time, Vent 90 degree 3" exit (One per fan venting or intake options) 116 g 3 hours 4 min 0.10mm layer height, 20% infill, PLA material.Used brim for adhesion.AssemblyPress fit: 2 18mm x 4 mm rare earth neodymium magnets per chute. To prevent sliding, Press fit: the toothpick and cut to about 4 mm to stick into the fan grill. (Caveat: AVOID The Spinning fan inside the fan grill. The Fan can be hit or held if the toothpick is too long). To complete assembly, place vents over respective grill openings centered and above. Slide down and move the toothpick fraction exposed into a top grill hole. Neodymium magnets fully engage strongly.If the toothpicks hit their marks; the vents line up and are tight with 1 mm gaps. Install vent hose 3” to your liking