MHQ2 Landing gear XT60 Plug LED Strip

*February 16, 2015* After printing and fitting the V2 on my MHQ2 I realized that while the landing gear works fine with the angled part facing out it hits one of the frame supports if you turn it around. Shaved off 1.8mm from the base to make it fit either way.

*Update* Feb 13, 2015 - After printing my first set I realized that I put the bolt holes in the wrong place. Corrected and uploaded a new STL.

Also added V2 with a 10mm wider base as well as correcting a few drawing errors.

I nee