RoBo 3D Hexagon Hot End with 40mm FAN NO LED

Just blocked off the LED holes
RoBo 3D Hexagon Hot End with 40mm FAN and LED - version 2.2

this version ( http://www.thingiverse.com/thing:593544) does not work.
It collides with the housing on the robo3d if its more than an few inches above the platten. Hoping this one will fit.
already have a good light system.. so.. just "UN LED'd" this one.
Left some outline of the led holes incase you wanted to drill them out later.

Prints fine, works nice. No clearance issues. Blows a bit