Free Other STL Download - Dewalt dcv586 couplings/adapters to fit starmix cycloneby ForFoxAix

These adapters can be used to connect the Dewalt dcv586 to the starmix dust cyclone.To be able to use the applied hose (that’s 58mm outer diameter, right angle) you also need a piece of 50mm pvc to be able to connect it to the vacuum.One part is modelled after Dewalts original connector, this part gets glued to one part of the pvc, the other part is glued on the other end of the pvc, the right angle hose (supplied with starmix cyclone) should fit over this other part.The last part fits over the original dewalt port (which normally is connected to the vacuum) so it can be inserted into the dust cyclone.I haven’t tested it myself yet. Lmk if you run into issuesBe sure to check for print orientation and use proper infill, since this will be parts that are subject to forces by constantly inserting and removing into cyclone/vacuum etc. Oh and use petg at minimum off